With Consult-II

Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.

Fig 1: Scan Tool Display - Data Monitior
Courtesy of NISSAN MOTOR CO., U.S.A.
Crank engine for at least 2 seconds and run it for at least 5 seconds at idle speed.
If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .
If 1st trip DTC is not detected, go to next step.
Maintaining engine speed at more than 800 RPM for at least 5 seconds.
If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .