FixVault
Home › Infiniti › 2005 › FX45 › Repair and Diagnosis › Engine Performance › Engine Control System - VK45DE › DTC P1706: PNP Switch › DTC Confirmation Procedure › With Consult-II

With Consult-II

  1. Turn ignition switch ON.
  2. Select "P/N POSI SW" in "DATA MONITOR" mode with CONSULT-II. Then check the "P/N POSI SW" signal under the following conditions.
    POSITION (SELECTOR LEVER) AND KNOWN-GOOD SIGNAL

    Position (Selector lever) Known-good signal
    N or P position ON
    Except above position OFF
    Fig 1: Displaying Data Monitor
    G02358772Courtesy of NISSAN MOTOR CO., U.S.A.

    If NG, go to "DIAGNOSTIC PROCEDURE  ".

    If OK, go to following step.

  3. Select "DATA MONITOR" mode with CONSULT-II.
  4. Start engine and warm it up to normal operating temperature.
  5. Maintain the following conditions for at least 60 consecutive seconds.
    ENG SPEED REFERENCE CHART

    ENG SPEED 1,200 - 6,375 rpm
    COOLAN TEMP/S More than 70°C (158°F)
    B/FUELSCHDL 2.0 - 31.8 msec
    VHCL SPEED SE More than 64 km/h (40 MPH)
    Selector lever Suitable position
    Fig 2: Displaying Data Monitor
    G02358773Courtesy of NISSAN MOTOR CO., U.S.A.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE  "
About FixVault