With Consult-II

Start engine (VDC switch OFF).
Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT-II. The vehicle speed on CONSULT-II should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.
If NG, go to "Diagnostic Procedure ".

If OK, go to following step.
Select "DATA MONITOR" mode with CONSULT-II.
Warm engine up to normal operating temperature.

Maintain the following conditions for at least 60 consecutive seconds.

CONDITION MAINTAIN

ENG SPEED	1,700 - 6,000 RPM
COOLAN TEMP/S	More than 70°C (158°F)
B/FUEL SCHDL	5.5 - 31.8 (A/T) msec
B/FUEL SCHDL	5.0 - 31.8 (M/T) msec
Shift lever	Except P or N position (A/T) Except Neutral position (M/T)
PW/ST SIGNAL	OFF

Fig 1: Selecting "DATA MONITOR" Mode With CONSULT-II

Courtesy of NISSAN MOTOR CO., U.S.A.