Ignition Signal Check

WARNING: This page is about a different variant/trim than selected.

CHECK FUSE
Check that the following fuses of the NAVI control unit are not blown.

Fig 1: Fuse Terminals Table
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG
1. OK: GO TO 2.
2. NG: If fuse is blown, be sure to eliminate case of malfunction before installing new fuse. Refer to POWER SUPPLY ROUTING CIRCUIT .
IGNITION SIGNAL CHECK
1. Turn ignition switch ON.
2. Check voltage between NAVI control unit harness connector and ground.
  
  Fig 2: Ignition Switch Terminals Table
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  Fig 3: Checking Voltage Between NAVI Control Unit Harness Connector And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK: Replace NAVI control unit.
2. NG: Repair harness or connector.