With GST

WARNING: This page is about a different variant/trim than selected.

Start engine and warm it up to normal operating temperature.
Check that voltage between ECM terminal 107 (Fuel tank temperature sensor signal) and ground is less than 4.2V.
Turn ignition switch OFF and wait at least 10 seconds.
Start engine and wait at least 20 seconds.
Select "Service $07" with GST.
If 1st trip DTC is detected, go to Diagnostic Procedure .

Fig 1: Checking DTC P0452 EVAP Control System Pressure Sensor Voltage
Courtesy of NISSAN MOTOR CO., U.S.A.