DTC Confirmation Procedure
NOTE:
If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
With CONSULT-II
- Turn ignition switch ON. (Do not start engine.)
- Select "ECU INPUT SIGNALS" or "MAIN SIGNALS" in "DATA MONITOR" mode for "A/T" with CONSULT-II.
- Touch "START".
- Start engine.
- Run engine for at least 2 consecutive seconds at idle speed.
- If DTC is detected, go to "Diagnostic Procedure ".