Component Inspection

THROTTLE CONTROL MOTOR 

1. Disconnect electric throttle control actuator harness connector.
2. Check resistance between terminals 1 and 2.

   Resistance: Approximately 1 - 15 Ω [at 25 °C (77°F)] 

3. If NG, replace electric throttle control actuator and go to next step.
4. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
5. Perform "IDLE AIR VOLUME LEARNING ".
   Fig 1: Identifying Resistance Between Electric Throttle Control Actuator Terminals 1 And 2

   Courtesy of NISSAN MOTOR CO., U.S.A.