Diagnostic Procedure

• Check the following if "CONTROLLER FAILURE [C1201]" is displayed in self-diagnosis results of CONSULT-II.

1. PERFORM SELF-DIAGNOSIS 

With CONSULT-II 

1. Turn ignition switch "ON". (Do not start engine.)
2. Select "SELF-DIAG RESULTS" mode for "ALL MODE AWD/4WD" with CONSULT-II.
3. Touch "ERASE".
4. Turn ignition switch "OFF" and wait at least 10 seconds.
5. Perform the self-diagnosis again.

Is the "CONTROLLER FAILURE [C1201]" displayed? 

YES: Replace AWD control unit. Refer to , "AWD CONTROL UNIT ".

NO: INSPECTION END