Trunk Lid Close Switch Check

CHECK TRUNK LID CLOSE SWITCH SIGNAL

Check voltage between auto trunk control unit connector and ground.

CONNECTOR VOLTAGE CHART

Connector	Terminals (Wire color)		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
B110	8 (W/R)	Ground	Trunk lid close switch pressed (ON)	0
B110	8 (W/R)	Ground	Other than above (OFF)	5

OK or NG

OK : Trunk lid close switch is OK.
NG : GO TO 2.

Fig 1: Checking Voltage Between Auto Trunk Control Unit Connector And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect auto trunk control unit and trunk lid close switch connector.
3. Check continuity between auto trunk control unit connector B110 terminal 8 and trunk lid close switch connector B309 terminal 2.
  8 (W/R) - 2 (W/R) : Continuity should exist.
4. Check continuity between auto trunk control unit connector B110 terminal 8 and ground.
  8 (W/R) - Ground : Continuity should not exist.
OK or NG
- OK : GO TO 3.
- NG : Repair or replace harness.
  
  Fig 2: Checking Continuity Between Auto Trunk Control Unit Connector B110 Terminal 8 And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK TRUNK LID CLOSE SWITCH

Check continuity between trunk lid close switch terminals 1 and 2.

CONTINUITY CHART

Terminals		Condition	Continuity
1	2	Trunk lid switch pressed (ON)	Yes
1	2	Other than above	No

Fig 3: Checking Continuity Between Trunk Lid Close Switch Terminals 1 And 2

G04129553

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK : GO TO 4.
NG : Replace trunk lid close switch.

TRUNK LID CLOSE SWITCH GROUND CIRCUIT CHECK
Check continuity between trunk lid close switch connector B309 terminal 1 and ground.

1 (B) - Ground : Continuity should exist.

OK or NG
- OK : Replace auto trunk control unit.
- NG : Repair or replace harness.
  
  Fig 4: Checking Continuity Between Trunk Lid Close Switch Connector B309 Terminal 1 And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.