Work Flow
- Check the symptom and customer's requests.
- Understand the outline of system. Refer to , "SYSTEM DESCRIPTION ".
- Perform the preliminary check. Refer to , "PRELIMINARY CHECK ".
- Perform the communication inspection. If CONSULT-II is used, refer to
, "IVMS COMMUNICATION INSPECTION ". If CONSULT-II is not used, refer to
, "COMMUNICATION DIAGNOSIS ". Is the communication diagnosis result OK?
- OK: GO TO step 7.
- NG: GO TO step 5
- Repair or replace depending on the diagnosis result.
- Perform the communication diagnosis again. If CONSULT-II is used, refer to
, "IVMS COMMUNICATION INSPECTION ". If CONSULT-II is not used, refer to
, "COMMUNICATION DIAGNOSIS ". Is communication diagnosis result OK?
- OK: GO TO step 7.
- NG: GO TO step 5.
- Perform the self-diagnosis. If CONSULT-II is used, refer to
, "IVMS COMMUNICATION INSPECTION ". If CONSULT-II is not used, refer to
, "COMMUNICATION DIAGNOSIS ". Is self-diagnosis result OK?
- OK: GO TO step 11.
- NG: GO TO step 8.
- Repair or replace depending on the diagnosis result.
- Perform the self-diagnosis again. If CONSULT-II is used, refer to
, "SELF-DIAGNOSIS RESULTS ", If CONSULT-II is not used, refer to
, "POWER DOOR LOCK SYSTEM SELF-DIAGNOSIS ". Is self-diagnosis result OK?
- OK: GO TO step 11.
- NG: GO TO step 8.
- Referring to trouble diagnosis chart, repair or replace the cause of the incident.
Refer to , "SYMPTOM CHART "
- Does power door lock system operate normally?
- YES : GO TO step 12.
- NO : GO TO step 10.
- Inspection END.