Check Hazard Reminder Operation

1. Remove electronic key from ignition key cylinder.
2. Check the signal between combination flasher unit connector and ground with oscilloscope.
   CONNECTOR SIGNAL CHART
   
   

   Connector	Terminal (Wire color)		Condition	Signal (Reference value)
   	(+)	(-)
   M19	6 (W/L)	Ground	LOCK switch ON with electronic key	Courtesy of NISSAN MOTOR CO., U.S.A.
   			UNLOCK switch ON with electronic key* *: In the state that hazard reminder operates.	Courtesy of NISSAN MOTOR CO., U.S.A.

   Fig 1: Checking Signal Between Combination Flasher Unit Connector And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

• OK : Check combination flasher unit. Refer to "TURN SIGNAL AND HAZARD WARNING LAMPS ".
• NG : GO TO 2.

1. Disconnect BCM and combination flasher unit connector.
2. Check continuity between BCM connector M4 terminal 7 and combination flasher unit connector M91 terminal 6.

   7 (W/L) - 6 (W/L) : Continuity should exist. 

3. Check continuity between BCM connector M4 terminal 7 and ground.

   7 (W/L) - Ground : Continuity should not exist. 

OK or NG 

• OK : Replace BCM.
• NG : Repair or replace harness.
  Fig 2: Checking Continuity Between BCM Connector M4 Terminal 7 And Ground

  Courtesy of NISSAN MOTOR CO., U.S.A.