FixVault
Home › Infiniti › 2006 › Q45 › Repair and Diagnosis › Engine Performance › System › Engine Control System - Q45 - Component & System Tests, Mil And Data Link Connector, Service Data And Specifications (SDS) › ASCD Brake Switch › Component Inspection › Stop Lamp Switch

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 3 and 4 under the following conditions.
    STOP LAMP SWITCH

    Condition Continuity
    When brake pedal: Fully released. Should not exist.
    When brake pedal: Slightly depressed. Should exist.

    If NG, adjust stop lamp switch installation, Refer to "BRAKE PEDAL ", and perform step  3 again.

    Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 3 And 4
    G04127792Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault