Check Park Position Switch

1. CHECK PARK POSITION SWITCH INPUT SIGNAL 
   1. Turn ignition knob LOCK position.
   2. Check voltage between Intelligent Key unit connector and ground.
      Fig 1: Identifying Voltage Between Intelligent Key Unit Harness Connector And Ground

      Courtesy of NISSAN MOTOR CO., U.S.A.
      PARK POSITION SWITCH INPUT SIGNAL
      
      

      Connector	Terminal (Wire color)		Condition	Voltage (V) (Approx.)
      	(+)	(-)
      M34	39 (R/Y)	Ground	When selector lever is locked at the "P" position	0
      			When selector lever is not locked at the "P" position	Battery voltage

   OK or NG 

   OK: Park position switch circuit is OK.

   NG: GO TO 2.

2. CHECK PARK POSITION SWITCH CIRCUIT 
   1. Disconnect A/T device (park position switch) connector.
   2. Check voltage between A/T device (park position switch) connector M67 terminal 3 (R/Y) and ground. (Check harness for open.)

      3 (R/Y) - Ground : Battery voltage 

      Fig 2: Identifying Voltage Between A/T Device (Park Position Switch) Connector M67 Terminal 3 (R/Y) And Ground

      Courtesy of NISSAN MOTOR CO., U.S.A.
   3. Check continuity between A/T device (park position switch) connector M67 terminals 3 (R/Y) and ground. (Check harness for short.)

      3 (R/Y) - Ground : Continuity should not exist. 

      Fig 3: Identifying Continuity Between A/T Device (Park Position Switch) Connector M67 Terminals 3 (R/Y) And Ground

      Courtesy of NISSAN MOTOR CO., U.S.A.

   OK or NG 

   OK: GO TO 3.

   NG: Repair or replace harness.

3. CHECK PARK POSITION SWITCH 

   Check continuity between A/T device (park position switch) terminals 2 and 3.

   Fig 4: Identifying Continuity Between A/T Device (Park Position Switch) Terminals 2 And 3

   Courtesy of NISSAN MOTOR CO., U.S.A.
   PARK POSITION SWITCH
   
   

   Terminal		Condition	Continuity
   2	3	When selector lever is not locked at the "P" position	No
   		When selector lever is locked at the "P" position	Yes

   OK or NG 

   OK: GO TO 4.

   NG: Replace back A/T device (park position switch).

4. PARK POSITION SWITCH GROUND CIRCUIT INSPECTION 

   Check continuity between A/T device (park position switch) connector M67 terminal 2 (B) and ground.

   2 (B) - Ground : Continuity should exist. 

   Fig 5: Identifying Continuity Between A/T Device Connector M67 Terminal 2 (B) And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Check harness connection.

NG: Repair or replace harness.