Stop Lamp Switch

WARNING: This page is about a different variant/trim than selected.

Check continuity between stop lamp switch terminals 3 and 4 under the following conditions.

TERMINAL CONTINUITY CHART

Condition	Continuity
Brake pedal: Fully released	Should not exist
Brake pedal: Slightly depressed	Should exist

If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step 3 again.

Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 3 And 4

Courtesy of NISSAN MOTOR CO., U.S.A.