Check front Door Key Cylinder Switch

With CONSULT-II 

Check ("KEY CYL LK-SW", "KEY CYL UN-SW") in "DATA MONITOR" mode for "POWER DOOR ROCK SYSTEM" with CONSULT-II. Refer to "DATE MONITOR "

Fig 1: CONSULT-II Display - DATA MONITOR

Without CONSULT-II 

1. Turn ignition switch OFF.
2. Check voltage between power window main switch connector and ground.
   VOLTAGE SPECIFICATION
   
   

   Terminals			Key position	Voltage (V) (Approx.)
   (+)		(-)
   Power window main switch connector	Terminal
   D10	4	Ground	Lock	0
   			Neutral / Unlock	5
   	6		Unlock	0
   			Neutral / Lock	5

   Fig 2: Checking Voltage Between Power Window Main Switch Connector And Ground

   

OK or NG 

OK: Further inspection is necessary. Refer to SYMPTOM CHART .

NG: GO TO 2.

1. Disconnect power window main switch and front door key lock assembly (driver side) connector.
2. Check continuity between power window main switch connector and front door lock assembly (driver side) connector.
   CONTINUITY SPECIFICATION
   
   

   A		B		Continuity
   Power window main switch connector	Terminal	Front door lock assembly (driver side) connector	Terminal
   D10	4	D14	6	Yes
   	6		5

OK or NG 

OK: GO TO 3.

NG: Repair or replace harness.

Fig 3: Checking Continuity Between Power Window Main Switch Connector And Front Door Lock Assembly Connector

Check continuity between front door lock assembly (driver side) connector ground.

OK or NG 

OK: GO TO 4.

NG: Repair or replace harness.

Fig 4: Checking Continuity Between Front Door Lock Assembly Connector Ground

Check front door lock assembly (driver side).

OK or NG 

OK: Further inspection is necessary. Refer to SYMPTOM CHART .

NG: Replace front door key cylinder (driver side) switch.

Fig 5: Checking Front Door Lock Assembly (Driver Side)