Intake Valve Timing Control Solenoid Valve

Check resistance between intake valve timing control solenoid valve terminals as follows.

RESISTANCE SPECIFICATION

Terminals	Resistance
1 and 2	7.0 - 7.5Ω [at 20°C (68°F)]
1 or 2 and ground	∞Ω (Continuity should not exist)

If NG, replace intake valve timing control solenoid valve.

If OK, go to next step.

Remove intake valve timing control solenoid valve.

Fig 1: Checking Resistance Between Intake Valve Timing Control Solenoid Valve Terminals
Courtesy of NISSAN NORTH AMERICA, INC.
Provide 12V DC between intake valve timing control solenoid valve terminals and then interrupt it. Make sure that the plunger moves as shown in the figure.
CAUTION: Do not apply 12V DC continuously for 5 seconds or more. Doing so may result in damage to the coil in intake valve timing control solenoid valve.

If NG, replace intake valve timing control solenoid valve.

NOTE: Always replace O-ring when intake valve timing control solenoid valve is removed.

Fig 2: Applying 12V DC Between Intake Valve Timing Control Solenoid Valve Terminals
Courtesy of NISSAN NORTH AMERICA, INC.