Component Function Check

1. Select "LIFT RR SW-UP", "LIFT RR SW-DN" in "Data monitor" mode with CONSULT-III.
2. Check lifting switch (rear) signal under the following conditions.
   MONITOR ITEM CONDITION CHART
   
   

   Monitor item	Condition		Status
   LIFT RR SW-UP	Lifting switch rear (up)	Operate	ON
   		Release	OFF
   LIFT RR SW-DN	Lifting switch rear (down)	Operate	ON
   		Release	OFF

Is the indication normal? 

YES: INSPECTION END

NO: Perform diagnosis procedure. Refer to , "DIAGNOSIS PROCEDURE ".