FixVault
Home › Infiniti › 2008 › G35 Base › Repair and Diagnosis › External Pages › Different car › Section 57 (Engine Control System - Component Testing) › On-Vehicle Repair › Intake Valve Timing Control › Intake Valve Timing Control Position Sensor (RH) › Removal

Intake Valve Timing Control Position Sensor (RH): Removal

WARNING: This page is about a different car, the 2008 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine room cover using power tool. Refer to "REMOVAL AND INSTALLATION ".
  2. Disconnect intake valve timing control position sensor connector (RH).
  3. Remove intake valve timing control position sensor (RH) (1) from Intake valve timing control solenoid valve cover (RH) (3).
    Fig 1: Identifying Intake Valve Timing Control Position Sensor (RH) Remove/Install Components
    G05378613Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault