FixVault
Home › Infiniti › 2008 › G37 Base › Repair and Diagnosis › Body & Frame › Seats › Automatic Drive Positioner › Basic Inspection › Inspection And Adjustment › System Initialization › SYSTEM INITIALIZATION : Special Repair Requirement › Initialization Procedure

Initialization Procedure

  1. STEP-1

    Make sure that the ignition position is in the LOCK position.

    GO TO 2.

  2. STEP-2

    Door switch is ON (open) → OFF (close) → ON (open).

    NOTE: STEP-1 and STEP-2 are the initialization procedures for synchronization function, memory function and Intelligent Key interlock function.

    STEP-1 and STEP-2 can be omitted by driving the vehicle at 25 km/h (16 MPH) or more.

    GO TO 3.

  3. STEP-3

    Slide the seat to the front edge.

    NOTE:
    • STEP-3 is the initialization procedure for power walk-in function.
    • If the seat sliding position is already at the front edge, slide the seat rearward once, and then slide it to the front edge again.

    END

About FixVault