FixVault
Home › Infiniti › 2008 › G37 Base › Repair and Diagnosis › External Pages › Different car › Section 34 (Transfer Case) › On-Vehicle Repair › Shift Control › Disassembly and Assembly › Assembly

Disassembly and Assembly: Assembly

WARNING: This page is about a different car, the 2008 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install clevis pin and shift collar to L-H shift fork after assembling them.
    CAUTION: Use caution when installing L-H shift fork, clevis pin or shift collar.
  2. Install clevis pin and shift collar to 2-4 shift bracket after assembling them.
    CAUTION: Use caution when installing 2-4 shift bracket.
  3. Install guide fork collar and 2-4 shift fork spring to the 2-4 shift fork, and then secure it with the new retaining ring.
    CAUTION:
    • Do not reuse retaining ring.
    • Be careful with orientation.
    Fig 1: Identifying Fork Guide Collar And Fork Spring
    G04898612Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Install the 2-4 shift bracket to the L-H shift rod.
  5. Install the new retaining pin evenly to the L-H shift rod.
    CAUTION: Do not reuse retaining pin.
    Fig 2: Identifying Snap Ring And Retaining Pin
    G04898607Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Install the drum cam to the control shift rod, and then secure it with the new retaining pin.
    CAUTION: Do not reuse retaining pin.
  7. Install the new snap ring to the control shift rod.
CAUTION: Do not reuse snap ring.
Fig 3: Identifying Snap Ring And Retaining Pin
G04898606Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault