Check 4WD Shift Indicator Pattern
WARNING: This page is about a different car, the 2008 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- Set 4WD shift switch to 2WD, 4H, 4LO, 4H and 2WD in order. Stay at each switch position for at least 2 seconds.
- Confirm 4WD shift indicator lamp and 4LO indicator lamp are changed properly as follows.
- If inspection results are normal, the position between transfer assembly and transfer control unit is correct.
- If inspection results are abnormal, the position is different between transfer assembly and transfer control unit.
Adjust the position between transfer assembly and transfer control unit. Refer to pattern table below.
Transfer position adjustment pattern
4WD SHIFT SWITCH CONDITION CHART
| 4WD shift switch condition | Refer procedure |
|---|---|
| 4WD shift switch is under 2WD condition when engine is being stopped. | METHOD FOR ADJUSTMENT WITH 4WD SHIFT SWITCH AT 2WD |
| 4WD shift switch is under 4H or 4LO condition when engine is being stopped. | METHOD FOR ADJUSTMENT WITH 4WD SHIFT SWITCH AT 4H OR 4LO |
NOTE:
Method of adjustment can be chosen voluntarily, according to location of 4WD shift switch.