Accelerator Pedal Position Sensor
- Reconnect all harness connectors disconnected.
- Turn ignition switch ON.
- Check voltage between ECM terminals 106 (APP sensor 1 signal), 98 (APP sensor 2 signal) and ground under the following conditions.VOLTAGE SPECIFICATION CHART
Terminal Accelerator pedal Voltage 106
(Accelerator pedal position sensor 1)Fully released 0.4 - 1.1V Fully depressed 3.7 - 4.8V 98
(Accelerator pedal position sensor 2)Fully released 0.20 - 0.55V Fully depressed 1.85 - 2.40V - If NG, replace accelerator pedal assembly and go to next step.
- Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
- Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
- Perform "IDLE AIR VOLUME LEARNING ".