FixVault

Display Item List

DISPLAY ITEM LIST

Item (Unit) Data monitor item selection Display content
ECU INPUT SIGNALS MAIN SIGNALS
FR LH SENSOR [km/h (MPH)] x x Wheel speed
FR RH SENSOR [km/h (MPH)] x x
RR LH SENSOR [km/h (MPH)] x x
RR RH SENSOR [km/h (MPH)] x x
STOP LAMP SW (ON/OFF) x x Stop lamp switch signal status (Brake pedal operation)
BATTERY VOLT (V) x x Battery voltage supplied to the ABS actuator and electric unit (control unit)
GEAR x x Gear position determined by TCM
STOP LAMP SW (On/Off) ? ? Stop lamp switch signal status
SLCT LVR POSI x x A/T select lever position
OFF SW (ON/OFF) x x VDC OFF switch
YAW RATE SEN (d/s) x x Yaw rate detected by yaw rate/side G sensor
ACCEL POS SIG (%) x - Throttle actuator opening/closing is displayed (Linked with accelerator pedal)
SIDE G-SENSOR (m/s2 ) x - Transverse G detected by side G sensor
STR ANGLE SIG (°) x - Steering angle detected by steering angle sensor
PRESS SENSOR (bar) x - Brake fluid pressure detected by pressure sensor
ENGINE RPM (rpm x - Engine speed (With engine running)
FLUID LEV SW (On/Off) x - Brake fluid level switch (signal status)
PARK BRAKE SW (ON/OFF) x - Parking brake switch
FR RH IN SOL (ON/OFF) - x Operation status of all solenoid valve
FR RH OUT SOL (ON/OFF) - x
FR LH IN SOL (ON/OFF) - x
FR LH OUT SOL (ON/OFF) - x
RR RH IN SOL (ON/OFF) - x
RR RH OUT SOL (ON/OFF) - x
RR LH IN SOL (ON/OFF) - x
RR LH OUT SOL (ON/OFF) - x
MOTOR RELAY (ON/OFF) - x Motor and motor relay operation
ACTUATOR RLY (ON/OFF) - x Actuator relay operation
ABS WARN LAMP (ON/OFF) - x ABS warning lamp
OFF LAMP (ON/OFF) - x VDC OFF indicator lamp
SLIP LAMP (ON/OFF) - x SLIP indicator lamp
BST OPER SIG - - Not applied but displayed.
EBD SIGNAL (ON/OFF) - - EBD operation
ABS SIGNAL (ON/OFF) - - ABS operation
TCS SIGNAL (ON/OFF) - - TCS operation
VDC SIGNAL (ON/OFF) - - VDC operation
EBD FAIL SIG (ON/OFF) - - EBD fail-safe signal
ABS FAIL SIG (ON/OFF) - - ABS fail-safe signal
TCS FAIL SIG (ON/OFF) - - TCS fail-safe signal
VDC FAIL SIG (ON/OFF) - - VDC fail-safe signal
CRANKING SIG (ON/OFF) - - Crank operation
USV[FR-RL] (ON/OFF) - - VDC switch-over valve
USV[FL-RR] (ON/OFF) - -
HSV[FR-RL] (ON/OFF) - -
HSV[FL-RR] (ON/OFF) - -
V/R OUTPUT (ON/OFF) - - Solenoid valve relay activated
M/R OUTPUT (ON/OFF) - - Actuator motor and motor relay activated
LDP) APP SEN (%) x x Accelerator pedal position sensor status received from ECM via CAN communication
LDP) Yaw order (?100Nm) - x Calculated target yaw moment
LDP) Shift position (OFF/P/R/N/D/MM 1st - MM 6th) x x Shift position received from TCM via CAN communication
LDP) ICC main SW (On/Off) x x ICC main switch status received from ECM via CAN communication
LDP) LDP ON SW (On/Off) x x LDP ON switch status received from ECM via CAN communication
LDP) Wiper signal (Stop/PRTCT/1low/1high/Low/High) x x Front wiper operating condition received from BCM via CAN communication
LDP) Turn signal (Off/LH/RH/LH&RH) x x Turn signal operating condition received from BCM via CAN communication
LDP) BRAKE SW (On/Off)) x x Brake switch signal status
LDP) STOP LMP SW (On/Off) x x Stop lamp switch signal status
LDP) WARN REQ (On/Off) - x Status of warning request that transmits to lane camera unit via CAN communication
LDP) WARN control (On/Off) - x Status of warning main controller for LDP
LDP) READY signal (On/Off) - x Status of internal judgment by LDP controller [ABS actuator and electric unit (control unit)]
LDP) STATUS signal (STANDBY/WARN/MASK/Off) - x Status of internal judgment by LDP controller [ABS actuator and electric unit (control unit)]
LDP) LDW SW (On/Off) x x LDW switch status received from lane camera unit via CAN communication
LDP) Camera lost (Detect/Deviate/Both) - x Lane marker detected condition received from lane camera unit via CAN communication
LDP) Lane unclear (On/Off) - x Lane marker condition received from lane camera unit via CAN communication
x: Applicable
-: Not applicable
NOTE: Only AWD models