DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.

CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for at least 2 consecutive seconds.
  MANU MODE SW : ON
  
  Is "P1815 MANU MODE SW/CIRC" detected?
  
  YES: Go to "DIAGNOSIS PROCEDURE ".
  
  NO: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".