General Information -- Convertible

• How To Use This Service Information
  • How To Use This Service Information
    • Description
    • Terms
    • Units
    • Relation between Illustrations and Descriptions
    • Components
      • Notes
      • Symbols
  • How To Follow Trouble Diagnoses
    • Description
    • How to Follow Test Groups in Trouble Diagnosis
    • Key to Symbols Signifying Measurements or Procedures
  • How To Read Wiring Diagrams
    • Connector Symbols
    • Sample/Wiring Diagram - Example-
    • Description
      • Notes
      • Switch Positions
      • Multiple Switch
  • Abbreviations
    • Abbreviation List
  • Tightening Torque Of Standard Bolts
    • Description
    • Tightening Torque Table (New Standard Included)
      • Notes
      • Previous Standard
      • New Standard Based On ISO
      • Discrimination Of Bolts And Nuts
  • Recommended Chemical Products And Sealants
    • Recommended Chemical Products and Sealants
• Vehicle Information
  • Identification Information
    • Model Variation
    • Information About Identification or Model Code
      • Identification Number
      • Vehicle Identification Number Arrangement
      • Identification Plate
      • Engine Serial Number
      • Automatic Transmission Number
      • Manual Transmission Number
    • Dimensions
    • Wheels & Tires
• Precaution
  • Precautions
    • Description
    • Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
      • Notes
      • Precautions When Using Power Tools (Air Or Electric) And Hammers
    • Precautions For Xenon Headlamp Service
    • Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
      • Notes
      • Operation Procedure
    • Precaution for Battery Service
    • Precaution for Procedure without Cowl Top Cover
    • Service Procedure Precautions for Models with a Pop-up Roll Bar
    • General Precautions
    • Three Way Catalyst
    • Multiport Fuel Injection System or Engine Control System
    • Hoses
      • Hose Removal And Installation
      • Hose Clamping
    • Engine Oils
      • Notes
      • Health Protection Precautions
      • Environmental Protection Precautions
    • Air Conditioning
      • Notes
      • Fuel
  • Lifting Point
    • Commercial Service Tools
    • Garage Jack and Safety Stand and 2-Pole Lift
    • Board-On Lift
  • Tow Truck Towing
    • Tow Truck Towing
      • Notes
      • 2WD Models
    • Vehicle Recovery (Freeing a Stuck Vehicle)
      • Front
      • Rear
      • Automatic Transmission
• Basic Inspection
  • Service Information For Electrical Incident
    • Work Flow
      • Work Flow
    • Control Units and Electrical Parts
      • Precautions
    • How to Check Terminal
      • Connector And Terminal Pin Kit
      • How To Probe Connectors
        • Notes
        • Probing from Harness Side
        • Probing from Terminal Side
        • How to Check Enlarged Contact Spring of Terminal
        • Waterproof Connector Inspection
        • Terminal Lock Inspection
    • Intermittent Incident
      • Description
      • Vehicle Vibration
        • Notes
        • Connector & Harness
        • Hint
        • Sensor & Relay
        • Engine Compartment
        • Behind the Instrument Panel
        • Under Seating Areas
      • Heat Sensitive
      • Freezing
      • Water Intrusion
      • Electrical Load
      • Cold Or Hot Start Up
    • Circuit Inspection
      • Description
      • Testing For "Opens" In The Circuit
        • Notes
        • Continuity Check Method
        • Voltage Check Method
      • Testing For "Shorts" In The Circuit
        • Notes
        • Resistance Check Method
        • Voltage Check Method
      • Ground Inspection
      • Voltage Drop Tests
        • Notes
        • Measuring Voltage Drop - Accumulated Method
        • Measuring Voltage Drop - Step-by-Step
      • Control Unit Circuit Test
        • System Description
  • Consult-III/GST Checking System
    • Description
    • CONSULT-III Function and System Application*1
    • CONSULT-III/GST Data Link Connector (DLC) Circuit
      • Inspection Procedure
    • Wiring Diagram - CONSULT-III/GST CHECKING SYSTEM -
  • Inspection And Adjustment
    • Additional Service When Removing Battery Negative Terminal
      • ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Required Procedure After Battery Disconnection