Component Inspection (ICC Brake Switch)

1. CHECK ICC BRAKE SWITCH-I
   1. Turn ignition switch OFF.
   2. Disconnect ICC brake switch harness connector.
   3. Check the continuity between ICC brake switch terminals under the following conditions.
   CONTINUITY REFERENCE
   
   

   Terminals	Condition		Continuity
   1 and 2	Brake pedal	Fully released	Existed
   		Slightly depressed	Not existed

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: GO TO 2.

2. CHECK ICC BRAKE SWITCH-II

1. Adjust ICC brake switch installation. Refer to "INSPECTION AND ADJUSTMENT ".
2. Check the continuity between ICC brake switch terminals under the following conditions.

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace ICC brake switch.