4WAS Communication Line

Solder the repaired area and wrap tape around the soldered area.

NOTE: A fray of twisted lines must be within 110 mm (4.33 in).

Fig 1: Identifying Soldered And Taped Area

Courtesy of NISSAN MOTOR CO., U.S.A.

Bypass connection is never allowed at the repaired area.

NOTE: Bypass connection may cause 4WAS communication error as spliced wires that are separate from the main line or twisted lines lose noise immunity.

Replace the applicable harness as an assembly if error is detected on the shield lines of 4WAS communication line.

Fig 2: Caution For Bypass Connection

Courtesy of NISSAN MOTOR CO., U.S.A.