Operation Condition
WARNING: This page is about a different car, the 2008 Infiniti M45 and 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.
If the following conditions are not satisfied, memory switch operation is not performed.
- Ignition switch is in ON position.
- Driver side power seat switch, ADP steering switch and door mirror control switch are not operated.
- Seat memory switch and set switch are not operated.
- Output malfunction is not detected.
- CAN and UART communications are normal.
- A/T selector lever position is in P position.
- Detention switch malfunction is not detected.
[Detention switch malfunction is sensed when detention switch remains OFF, vehicle speed is higher than 7 km/H. (4 MPH).]
- Input voltage from tilt sensor and telescopic sensor are normal.
NOTE:
The memory operation operates following order.
MEMORY OPERATION
| Order of priority | Operated portion | ||
|---|---|---|---|
| 1(1) | Seat sliding | ||
| 2 | Steering telescopic | ||
| 3 | Steering wheel tilt | ||
| 4 | Seat reclining | ||
| 5 | Seat lifter (front) | ||
| 6 | Seat lifter (rear) | ||
|
|||