Active Test

WARNING: This page is about a different car, the 2008 Infiniti M45 and 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Can be tested only when swivel actuator initialization is completed. If initialization is not completed, "RETRY COMMAND" is displayed and cannot be tested.

LOW BEAM TEST RIGHT

Low beam headlamp (right) can be operated to swivel angle 0° by touching "ORIGIN", and to maximum angle by "PEAK".

LOW BEAM TEST RIGHT CHART

Test Item	Swivel Speed	Mode
ORIGIN/PEAK - FAST	Three times fast as SLOW	Normal operation
ORIGIN/PEAK SLOW	-	Initialization

Fig 1: CONSULT-III Display - ACTIVE TEST (Low Beam Test Right)

Courtesy of NISSAN MOTOR CO., U.S.A.

LOW BEAM TEST LEFT

Low beam headlamp (left) can be operated to swivel angle 0° by touching "ORIGIN", and to maximum angle by "PEAK".

LOW BEAM TEST LEFT CHART

Test Item	Swivel Speed	Mode
ORIGIN/PEAK - FAST	Three times fast as SLOW	Normal operation
ORIGIN/PEAK - SLOW	-	Initialization

Fig 2: CONSULT-III Display - ACTIVE TEST (Low Beam Test Left)

Courtesy of NISSAN MOTOR CO., U.S.A.

LEVELIZER TEST

Aiming motor drive signal can be changed to approx. 85% (ratio to IGN power supply) by touching "ORIGIN", and to approx. 15% by "PEAK". That angles headlamp LO up and down.

LEVELIZER TEST CHART

Test Item	Aiming Motor Drive Signal		Light Axis (Reference Value)
Test Item	Ratio to IGN power supply	Voltage	Light Axis (Reference Value)
ORIGIN	Approx. 85%	Approx. 10.6 V	0°
PEAK	Approx. 15%	Approx. 1.9 V	Approx. 2.5° (Relatively lower than that of origin)