FixVault
Home › Infiniti › 2009 › M45 Base › Repair and Diagnosis › Body & Frame › Seats › Service Information › Automatic Drive Positioner › Check Door Mirror Sensor RH Circuit

Check Door Mirror Sensor RH Circuit

  1. CHECK DOOR MIRROR FUNCTION

    Check the following items.

    Operation malfunction in memory operation.

    NOTE: If a door mirror face position is set to an implausible angle, the set position may not be reproduced.

    OK or NG 

    OK: GO TO 2.

    NG: Repair or replace the malfunctioning parts, and check the symptom again.

  2. CHECK DOOR MIRROR RH SENSOR

    With CONSULT-III 

    Check that "VOLTAGE" is displayed on "MIR/SEN RH R-L, MIR/SEN RH U-D" in the DATA MONITOR.

    MONITOR ITEM CHART

    Monitor item [OPERATION or UNIT] Contents
    MIR/SEN RH R-L "V" Voltage output from door mirror RH sensor (LH/RH) is displayed.
    MIR/SEN RH U-D "V" Voltage output from door mirror RH sensor (UP/DOWN) is displayed.

    Without CONSULT-III 

    1. Turn ignition switch to ACC.
    2. Check voltage between automatic drive positioner control unit connector and ground.
      VOLTAGE SPECIFICATION

      Automatic drive positioner control unit Terminals Condition Voltage (V) (Approx.)
      (+) (-)
      M6 21 Ground Mirror motor is operated UP or DOWN Changes between 3.5 (close to left edge) - 0.5 (close to right edge)
      5 Mirror motor is operated UP or DOWN Changes between 4.2 (close to peak) - 0.5 (close to valley)
      Fig 1: Checking Voltage Between Automatic Drive Positioner Control Unit Connector And Ground
      G05212953Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG 

      OK: Mirror sensor RH circuit is OK.

      NG: GO TO 3.

  3. CHECK HARNESS CONTINUITY 1
    1. Turn ignition switch OFF.
    2. Disconnect automatic drive positioner control unit connector and door mirror RH connector.
    3. Check continuity between automatic drive positioner control unit connector and door mirror RH connector.
      CONTINUITY CHART

      A B Continuity
      Automatic drive positioner control unit connector Terminal Door mirror RH connector Terminal
      M7 33 D39 11 Yes
      41 12
    4. Check continuity between automatic drive positioner control unit connector and ground.
      CONTINUITY CHART

      A Ground Continuity
      Automatic drive positioner control unit connector Terminal
      M7 33 No
      41
      Fig 2: Checking Continuity Between Automatic Drive Positioner Control Unit And Door Mirror Connector LH/RH And Ground
      G05212950Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG 

      OK: GO TO 4.

      NG: Repair or replace harness.

  4. CHECK HARNESS CONTINUITY 2
    1. Check continuity between automatic drive positioner control unit connector and door mirror RH connector.
      CONTINUITY CHART

      A B Continuity
      Automatic drive positioner control unit connector Terminal Door mirror RH connector Terminal
      M6 5 D39 9 Yes
      21 10
    2. Check continuity between automatic drive positioner control unit connector and ground.
      CONTINUITY CHART

      A Ground Continuity
      Automatic drive positioner control unit connector Terminal
      M6 5 No
      21
      Fig 3: Checking Continuity Between Automatic Drive Positioner Control Unit Connector And Ground
      G05212955Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG 

      OK: Replace door mirror RH.

      NG: Repair or replace harness.

About FixVault