Front Axle Hub: Reassembly

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not allow foreign matter, etc. to contact the ABS rotor bearing.

INSTALL FRONT AXLE HUB OIL SEAL
1. Using SST and a press, press in a new oil seal.
  SST: 09608-36010
  
  SST: 09950-70010 (09951-07100)
  
  NOTE: Do not damage the oil seal.
  
  Fig 1: Tapping In Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY
1. Using SST and a press, press in a new bearing.
  SST: 09608-32010
  
  NOTE: Insert 4 bolts into the bearing before installing the axle hub.
  
  NOTE: Make sure to securely fit the bearing to the axle hub.
  
  Fig 2: Pressing Bearing To Front Axle Hub Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT WHEEL ADJUSTING NUT (for 2WD)
1. Using SST, install a new adjusting nut.
  SST: 09602-60010
  
  Torque: 382 N*m (3895 kgf*cm, 282 ft.*lbf)
  
  Fig 3: Tightening Adjusting Nut Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002