Disassembly and Assembly of Combination Meter: Disassembly

WARNING: This page is about a different car, the 2008 Infiniti FX45 and 2008 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

Remove screws (A) and remove rear cover (1).

Fig 1: Identifying Screws And Rear Cover
Courtesy of NISSAN MOTOR CO., U.S.A.
Disconnect odo/trip meter and illumination control switch connector (2).
Remove screws (A).

Fig 2: Identifying Rear Cover Screws
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove tabs (A) and remove switch and meter housing (1).

Fig 3: Identifying Tabs, Switch And Meter Housing
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove screws (A) and remove reinforcing metal (1).

Fig 4: Identifying Screws And Reinforcing Metal
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove screws (A) and remove plate (1).

Fig 5: Identifying Screws And Plate
Courtesy of NISSAN MOTOR CO., U.S.A.
Disengage tabs (A) to separate front cover (1).

Fig 6: Identifying Tabs On Front Cover

Courtesy of NISSAN MOTOR CO., U.S.A.