FixVault
Home › Infiniti › 2009 › M45 Base › Repair and Diagnosis › External Pages › Different car › Section 65 (Driver Information System) › Warning Chime › Combination Meter Buzzer Circuit Inspection

Combination Meter Buzzer Circuit Inspection

WARNING: This page is about a different car, the 2008 Infiniti FX45 and 2008 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK OPERATION OF COMBINATION METER BUZZER 
    1. Select "BUZZER" of "BCM" on CONSULT-III.
    2. Perform "LIGHT WARN ALM", "IGN KEY WARN ALM" or "SEAT BELT WARN TEST" of "ACTIVE TEST".
      3. Fig 1: Identifying CONSULT II -ACTIVE TEST
      G04903786Courtesy of NISSAN MOTOR CO., U.S.A.

    Does chime sound? 

    YES: GO TO  4.

    NO: GO TO 2.

  2. CHECK UNIFIED METER AND A/C AMP. INPUT SIGNAL 
    1. Select "METER A/C AMP" on CONSULT-III.
    2. Operate switches to meet the requirements to sound warning chime with "BUZZER" of "DATA MONITOR" and check operation status.

      "BUZZER" 

      When meeting the requirements to sound warning chime : ON 

      Except above : OFF 

    OK or NG 

    OK: GO TO 3.

    NG: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".

  3. CHECK BATTERY POWER SUPPLY CIRCUIT OF COMBINATION METER 

    Check battery power supply circuit of combination meter. Refer to "POWER SUPPLY AND GROUND CIRCUIT INSPECTION ".

    OK or NG 

    OK: Replace combination meter.

    NG: Check harness between combination meter and fuse.

  4. CHECK BATTERY POWER SUPPLY CIRCUIT OF UNIFIED METER AND A/C AMP. 

Check battery power supply circuit of unified meter and A/C amp. Refer to "POWER SUPPLY AND GROUND CIRCUIT INSPECTION ".

OK or NG 

OK: INSPECTION END

NG: Check harness between unified meter and A/C amp. and fuse.

About FixVault