FixVault
Home › Infiniti › 2010 › M35 Base › Repair and Diagnosis › Engine Performance › System › Engine Control System - System And Component Testing › Ignition Signal › Component Inspection (Condenser)

Component Inspection (Condenser)

  1. CHECK CONDENSER
    1. Turn ignition switch OFF.
    2. Disconnect condenser harness connector.
    3. Check resistance between condenser terminals as per the following.
      TERMINAL RESISTANCE CHART

      Terminals Resistance
      1 and 2 Above 1 MΩ [at 25°C (77°F)]

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace condenser.

      Fig 1: Checking Resistance Between Condenser Terminals 1 And 2
      G04875488Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault