FixVault
Home › Infiniti › 2011 › EX35 Base, AWD › Repair and Diagnosis › Electrical › Body Electrical › Power Control System › Power Distribution System › DTC/Circuit Diagnosis › DTC B2615: Blower Relay Circuit › Component Inspection

Component Inspection

  1. CHECK BLOWER RELAY
    1. Turn ignition switch OFF.
    2. Remove blower relay.
    3. Check the continuity between blower relay terminals.
      CONTINUITY SPECIFICATION

      Terminals Condition Continuity
      3 and 5 12 V direct current supply between terminals 1 and 2 Existed
      No current supply Not existed

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace blower relay.

      Fig 1: Checking Continuity Between Relay Terminals 3 And 5
      G04889520Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault