FixVault
Home › Infiniti › 2011 › EX35 Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 14 (Automatic Transmission) › Disassembly And Assembly › Oil Pump › Assembly

Oil Pump: Assembly

WARNING: This page is about a different car, the 2008 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install O-ring to oil pump cover.
    Fig 1: Removing/Installing O-Ring
    G04876096Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Install O-ring to oil pump housing.
    Fig 2: Removing/Installing O-Ring
    G04876095Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Using the drift, install oil pump housing oil seal to the oil pump housing until it is flush.
    CAUTION:
    • Do not reuse oil seal.
    • Apply ATF to oil seal.
      Fig 3: Installing Oil Pump Housing Oil Seal To Oil Pump Housing
      G04876099Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Install oil pump housing to oil pump cover.
  5. Tighten bolts (<=) to the specified torque in numerical order shown in the figure after temporarily tightening them.
    Fig 4: Locating Oil Pump Housing Bolts
    G05218916Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault