Component Function Check

1. Turn ignition switch OFF.
2. Disconnect EOT sensor harness connector.
3. Remove EOT sensor. Refer to "EXPLODED VIEW (2WD) " (2WD models) or "EXPLODED VIEW (AWD) " (AWD models).
4. Check resistance between EOT sensor terminals by heating with hot water as shown in illustration.

Fig 1: Checking Engine Coolant Temperature Sensor By Heating Hot Water

Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal? 

YES: GO TO 2.

NO: Proceed to "DIAGNOSIS PROCEDURE ".

Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

Is the inspection result normal? 

YES: INSPECTION END

NO: Proceed to "DIAGNOSIS PROCEDURE ".