Work Procedure

WARNING: This page is about a different car, the 2012 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

WRITING MODE SELECTION
With CONSULT: CONSULT Configuration

Select "CONFIGURATION" of CAN gateway.

When writing saved data: GO TO 2.

When writing manually: GO TO 3.
PERFORM "WRITE CONFIGURATION - CONFIG FILE"
With CONSULT: CONSULT Configuration

Perform "WRITE CONFIGURATION - Config file".

: GO TO 4.
PERFORM "WRITE CONFIGURATION - MANUAL SELECTION"
With CONSULT: CONSULT Configuration
1. Select "WRITE CONFIGURATION - Manual selection".
2. Select "SETTING".
3. When "COMMAND FINISHED", select "End".
  : GO TO 4.
CHECK "SELF DIAGNOSTIC RESULT"
1. Erase all ECU self-diagnosis results using CONSULT.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON and wait for 2 seconds or more.
4. Perform "All DTC Reading" using CONSULT.
5. Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.
  : WORK END