Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Disconnect VVEL control module harness connector.
4. Check the continuity between ECM harness connector and VVEL control module harness connector.
   CONTINUITY SPECIFICATION
   
   

   ECM		VVEL control module		Continuity
   Connector	Terminal	Connector	Terminal
   E80	161	F56	24	Existed
   	166		11

5. Also check harness for short to ground and short to power.

   Is the inspection result normal? 

   YES: GO TO  3.

   NO: GO TO 2.

Check the following.

• Harness for open or short between ECM and VVEL control module
• Loose or poor connection for each connector and harness

  Repair open circuit, short to ground or short to power in harness or connectors.

Refer to "INTERMITTENT INCIDENT ".

Is the inspection result normal? 

YES: GO TO 4.

NO: Repair or replace.

1. Replace VVEL control module.
2. Perform additional service when replacing VVEL control module. Refer to "WORK PROCEDURE ".

   GO TO 5.

WITH CONSULT-III

1. Reconnect all harness connectors disconnected.
2. Turn ignition switch ON.
3. Select "SELF DIAGNOSTIC RESULT" mode with CONSULT-III.
4. Touch "ERASE".
5. Perform DTC Confirmation Procedure.

   See "DTC LOGIC ".

WITH GST

1. Reconnect all harness connectors disconnected.
2. Turn ignition switch ON.
3. Select Service $04 with GST.
4. Perform DTC Confirmation Procedure.

   See "DTC LOGIC ".

   Is the DTC U1024 displayed again? 

   YES: GO TO 6.

   NO: INSPECTION END

1. Replace ECM.
2. Perform additional service when replacing ECM. Refer to "WORK PROCEDURE ".

   INSPECTION END