DTC Confirmation Procedure
CAUTION:
- Always drive vehicle at a safe speed.
- Be careful not to rev engine into the red zone on the tachometer.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
: GO TO 2.
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "ESTM VSP SIG" in "Data Monitor" in "TRANSMISSION".
- Drive vehicle and maintain the following conditions for 60 seconds or more:
ESTM VSP SIG: 40 km/h (25 MPH) or more
- Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST
Follow the procedure "With CONSULT".
Is "P0720" detected?
YES: Go to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END