Precautions for Drive Shaft

WARNING: This page is about a different variant/trim than selected.

Observe the following precautions when disassembling and assembling drive shaft.

Never disassemble joint sub-assembly because it is non-overhaul parts.
Perform work in a location which is as dust-free as possible.
Clean the parts, before disassembling and assembling.
Prevent the entry of foreign objects during disassembly of the service location.
Reassemble disassembled parts carefully in the correct order. If work is interrupted, a clean cover must be placed over parts.
Use paper waste. Fabric shop cloths must not be used because of the danger of lint adhering to parts.
Clean disassembled parts (except for rubber parts) with kerosene which shall be removed by blowing with air or wiping with paper waste.