Component Function Check
WARNING: This page is about a different car, the 2011 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FUNCTION
- Turn ignition switch ON.
- Select "TILT SEN" in "Data monitor" mode with CONSULT-III.
- Check the tilt sensor signal under the following condition.MONITOR ITEM CONDITION
Monitor item Condition Value TILT SEN Tilt position Change between
1.2 [V] (Close to top)
3.4 [V] (Close to bottom)Is the indication normal?
YES: INSPECTION END
NO: Perform diagnosis procedure. Refer to "DIAGNOSIS PROCEDURE ".