Work Procedure

WARNING: This page is about a different car, the 2011 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

Two positions for the driver seat, steering column, and outside mirror can be stored for memory operation by following procedure.

NOTE: If memory is stored in the same memory switch, the previous memory will be deleted.

STEP 1
Check the following conditions.
- Ignition switch: ON
- CVT shift selector: P position
  GO TO 2.
STEP 2
1. Adjust driver seat and outside mirror position manually.
2. Push set switch.
  NOTE:
  - Memory indicator for which driver seat position is already retained in memory is illuminated for 5 seconds.
  - Memory indicator for which driver seat position is not retained in memory is illuminated for 0.5 second.
3. Push the memory switch (1 or 2) for at least 1 second within 5 seconds after pushing the set switch.
  NOTE:
  - To enter driver seat positions into blank memory, memory indicator will be turned on for 5 seconds.
  - To modify driver seat positions, memory indicator will be turned OFF for 0.5 second, then turned ON for 5 seconds.
4. Confirm the operation of each part with memory operation.
  END