Diagnosis Procedure
WARNING: This page is about a different car, the 2011 Nissan 370Z. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK KEY SLOT INDICATOR OUTPUT SIGNAL
Check voltage between key slot harness connector and ground.
VOLTAGE SPECIFICATIONKey slot (-) Condition Key slot illumination Voltage (V) (Approx.) (+) Connector Terminal M22 6 Ground Insert Intelligent Key into key slot OFF Battery voltage Remove Intelligent Key from key slot ON 0 Is the inspection result normal?
YES: Go to 5.
NO: Go to 2.
- CHECK KEY SLOT POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect key slot connector.
- Check voltage between key slot harness connector and ground.VOLTAGE SPECIFICATION
Key slot (-) Voltage (V) (Approx.) (+) Connector Terminal M22 1 Ground Battery voltage 5 Is the inspection result normal?
YES: Go to 3.
NO-1: Check 10 A fuse [No. 6 and 9 located in the fuse block (J/B)].
NO-2: Check harness for open or short between key slot and fuse.
- CHECK KEY SLOT GROUND CIRCUIT
Check continuity between key slot harness connector and ground.
CONTINUITY SPECIFICATIONKey slot Ground Continuity Connector Terminal M22 7 Existed Is the inspection result normal?
YES: Go to 4.
NO: Repair or replace key slot ground circuit.
- CHECK KEY SLOT CIRCUIT
- Turn ignition switch OFF.
- Disconnect BCM connector.
- Check continuity between BCM harness connector and key slot harness connector.CONTINUITY SPECIFICATION
BCM Key slot Continuity Connector Terminal Connector Terminal M122 92 M22 6 Existed - Check continuity between BCM harness connector and ground.CONTINUITY SPECIFICATION
BCM Ground Continuity Connector Terminal M122 92 Not existed Is the inspection result normal?
YES: Replace key slot. Refer to "REMOVAL AND INSTALLATION ".
NO: Repair or replace harness.
- CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".
INSPECTION END