Special Repair Requirement

Memory Storage Procedure

Two positions for the driver seat, steering column and outside mirror can be stored for memory operation by following procedure.

1. STEP 1

   Check the following conditions.

   • Ignition switch: ON
   • A/T selector lever: P position

   : GO TO 2.

2. STEP 2

   Adjust driver seat, steering column and outside mirror position manually.

   : GO TO 3.

3. STEP 3
   1. Push set switch.
      NOTE:

      • Memory indicator for which driver seat position is already retained in memory is illuminated for 5 seconds.
      • Memory indicator for which driver seat position is not retained in memory is illuminated for 0.5 second.
   2. Push the memory switch (1 or 2) for at least 1 second within 5 seconds after pushing the set switch.
   NOTE:

   • To enter driver seat positions into blank memory, memory indicator will be turned on for 5 seconds.
   • To modify driver seat positions, memory indicator will be turned OFF for 0.5 second, then turned ON for 5 seconds.
   NOTE: If memory is stored in the same memory switch, the previous memory will be deleted.

   : GO TO 4.

4. STEP 4

   Confirm the operation of each part with memory operation.

   : END