DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

: GO TO 2.

◦ With CONSULT

1. Perform "INSPECTION MODE 5". Refer to "DESCRIPTION ".
2. Start engine and wait at least 5 seconds.
3. Perform "All DTC Reading".
4. Check DTC of "MOTOR CONTROL".

   Is the DTC U0100, U0101, U0111 or U0293 detected? 

   YES: GO TO 3.

   NO-1 (DTC U0100, U0101, U0111 or U0293 is stored in "Motor Control" at the time of receiving.): GO TO 3.

   NO-2 (Repaired after performing "DIAGNOSIS PROCEDURE ".): INSPECTION END

◦ With CONSULT

1. Perform "CAN Diagnosis".
2. Check diagnosis results.

   : Proceed to "DIAGNOSIS PROCEDURE ".