Work Step
When removing instrument panel assembly, combination meter, AV control unit, instrument finisher A, instrument finisher B, and center console assembly take steps as per the order shown in the following chart.
| PARTS | INSTRUMENT PANEL ASSEMBLY | COMBINATION METER | AV CONTROL UNIT | INSTRUMENT FINISHER A | INSTRUMENT FINISHER B | CENTER CONSOLE ASSEMBLY |
|---|---|---|---|---|---|---|
| Cluster lid C | [1] | [1] | [1] | |||
| Select lever knob | [2] | [2] | [2] | |||
| Instrument side panel LH | [3] | [3] | [3] | |||
| Instrument side panel RH | [4] | [4] | [4] | |||
| Console mask | [5] | [5] | [5] | |||
| Console finisher assembly | [6] | [6] | ||||
| Console rear finisher | [7] | [7] | ||||
| Center console assembly | [8] | [8] | ||||
| Driver air bag module | [9] | |||||
| Steering wheel | [10] | |||||
| Steering column covers | [11] | |||||
| Spiral cable | [12] | |||||
| Combination switch | [13] | |||||
| Cluster lid A (upper) | [14] | [1] | ||||
| Cluster lid A | [15] | [2] | ||||
| Combination meter | [16] | [3] | ||||
| Connector clip and harness clip behind combination meter | [17] | |||||
| Inside key antenna and harness clamp | [18] | |||||
| Preset switch | [19] | [6] | ||||
| Cluster lid D | [20] | [7] | ||||
| AV control unit | [21] | [8] | ||||
| Center ventilator assembly | [22] | |||||
| Display unit | [23] | |||||
| Instrument side finisher LH | [24] | [1] | ||||
| Front body side welt LH | [25] | [2] | ||||
| Front pillar garnish LH | [26] | |||||
| Instrument lower panel LH | [27] | [3] | ||||
| Instrument finisher A | [4] | |||||
| Push button ignition switch | [28] | |||||
| Upper ventilator grille | [29] | |||||
| Center speaker | [30] | |||||
| Front defroster grille LH | [31] | |||||
| Front defroster grille RH | [32] | |||||
| Instrument side finisher RH | [33] | [1] | ||||
| Front body side welt RH | [34] | [2] | ||||
| Front pillar garnish RH | [35] | |||||
| Instrument lower cover | [36] | [3] | ||||
| Glove box assembly | [37] | [4] | ||||
| Instrument lower panel RH | [38] | [5] | ||||
| Instrument finisher B | [6] | |||||
| Passenger air bag module mounting bolt and passenger air bag module harness connector | [39] | |||||
| Instrument panel assembly mounting bolts, screws, and clips | [40] | |||||
| Instrument panel assembly | [41] | |||||
| []: Number indicates step in removal procedure. | ||||||
WARNING:
Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more.
CAUTION:
When removing, always use a remover tool that is made of plastic.