FixVault
Home › Infiniti › 2012 › M37 Base › Repair and Diagnosis › External Pages › Different car › Section 82 (Automatic Transmission) › Basic Inspection › Additional Service When Replacing Transmission Assembly › Special Repair Requirement

Special Repair Requirement

WARNING: This page is about a different car, the 2013 Infiniti M56 and 2013 Infiniti M37. However, it is still accessible from the selected car via links, so may be relevant.
  1. PREPARATION BEFORE CALIBRATION PROCEDURE 
    1. Park the vehicle on a flat road.
    2. Adjust pressure in all tires to the specified value. Refer to "TIRE AIR PRESSURE ".

      GO TO 2.

  2. PERFORM CALIBRATION 

    With CONSULT 

    1. Turn ignition switch ON.
      CAUTION: Never start the engine.
    2. Select "G SENSOR CALIBRATION" in "Work Support" in "TRANSMISSION".
    3. Touch "START".
      CAUTION: Never give any motion to the vehicle during the calibration.

    Is "completed" displayed? 

    YES: GO TO 3.

    NO: Perform the calibration again.

  3. CHECK DTC 

    With CONSULT 

    1. Turn ignition switch OFF and wait 10 seconds or more.
    2. Turn ignition switch ON.
    3. Select "Self Diagnostic Results" in "ABS".

    Is "C1145" or "C1146" detected? 

    YES: Refer to "DTC INDEX ".

    NO: Calibration end.

About FixVault