Front Wheel Turning Angle

Perform toe-in inspection. Refer to "INSPECTION " (2WD), "INSPECTION " (AWD).
CAUTION: Perform front wheel turning angle inspection, after toe-in inspection.
Place front wheels on turning radius gauges and rear wheels on stands, so that vehicle can be level.
Check the maximum inner and outer wheel turning angles for LH and RH road wheels.

Fig 1: Checking Front Wheel Turning Angle
Courtesy of NISSAN NORTH AMERICA, INC.
- With the engine at idle, turn steering wheel from full left stop to full right stop and measure the turning angles.
  Inner wheel (Angle: A): Refer to "STEERING ANGLE ".
  
  Outer wheel (Angle: B): Refer to "STEERING ANGLE ".
  
  Fig 2: Measuring Turning Angle
  Courtesy of NISSAN NORTH AMERICA, INC.
- Check the following items when turning angle is out of the standard.
  - Check the neutral position of the rack stroke (L).
    Rack stroke neutral position (L): Refer to "RACK STROKE ".
  - Disassemble steering gear assembly to check the cause that rack stroke is outside of the standard.
- Steering angles are not adjustable. Check steering gear assembly, steering column assembly and front suspension components for wear or damage if any of the turning angles are different from the specified value. Replace any of them, if any non-standard condition exists.
  
  Fig 3: Identifying Rack Stroke Length
  Courtesy of NISSAN NORTH AMERICA, INC.