DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

: GO TO 2.
CHECK DTC DETECTION
With CONSULT
1. Start the engine.
2. Select "SLCT LVR POSI", "GEAR", "VHCL/S SE-A/T", "CLSD THL POS" and "ENGINE SPEED" in "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for 5 seconds or more.
  CAUTION: Keep the same gear position.
  
  NOTE: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
  
  SLCT LVR POSI: D
  
  GEAR: 2nd, 3rd, 4th, 5th or 6th
  
  VHCL/S SE-A/T: More than 40 km/h (25 MPH)
  
  CLSD THL POS: OFF
  
  ENGINE SPEED: More than 1, 500 RPM
4. Perform "Self Diagnostic Results" in "TRANSMISSION".
  With GST
  
  Follow the procedure "With CONSULT".
  
  Is "P0717" detected?
  
  YES: Go to "DIAGNOSIS PROCEDURE ".
  
  NO: INSPECTION END